Syracuse 10 Minute Water Heater Maintenance Check

Posted by on Feb 26, 2014 in Water Heater Repair Syracuse NY

We are going to put you to work today, however just for about 10 minutes. Yep, that’s all it will consider these 2 important water heater maintenance tasks; nevertheless, Water Heater Repair Syracuse NY¬†knows they will do an excellent task of helping with three things:

  1. Having your water heater last as long as possible (that will save you cash).
  2. Ensuring the water heater runs safely (we do not desire it to blow up).
  3. Having it run as energy efficiently as possible (likewise conserving you money).

So with that in mind, are you ready to invest ten minutes once or two times a year to assist in saving some cash? Water Heater Repair Syracuse thought so.

Testing the T&P Relief Valve

Commonly called the T&P Valve, or the temperature and pressure relief valve, has an important job. It assists see to it excess pressure does not develop inside the water tank, or in much more basic terms, it makes sure the water heater does not explode. As the image shows, it has a lever or little handle on it. All you have to do is raise it part method then let go of it. Ideally, it snapped back to its closed position quickly. If it is working correctly, a little water can be heard going into the drain pipe below the lever you just raised and you perhaps heard some pressure being released. If none of these things have taken place during the test, the valve will have to be replaced.

As inspectapedia.com states: “dripping TP relief valves are unsafe. The hazard is that minerals in the water supply accumulate inside the valve during the passage of hot water through the valve assembly. That accumulation of scale will eventually block operation of the relief valve, causing the relief valve to fail to operate properly if unsafe pressure or temperature occurs in the water heater in the future. The risk, ultimately, is a water heater tank or heating boiler explosion.” ¬†(read more…)

Do a Mimi Water Heater Tank Flush

By nature, rust and corrosion will occur inside the water tank thanks to the chemical reactions taking place with all the parts inside that are needed to warm the water. We will not get too technical here, however it is simple to help prevent this from happening by doing a flush or draining of all or some of the water in the tank.

For just a small flush, put a pail under the drain valve below the tank. Open the drain valve and fill the pail with water. Drain at least a few gallons of water in total. Let the water sit in the container for a few minutes to settle and examine if there is much that settles to the bottom of the container. If there is, if the water heater has not been drained for a long period of time (or ever), it would be best to do a full flush of the tank to get as much of the sediment out as possible. You will wish to turn the temperature dial down and could desire to let the water cool down for about an hour initially so it is not too hot while draining it. Likewise, it would be easier to connect a hose to the drain valve and let the water go outside instead of using buckets.

If the water looks reasonably clean and clear from the small test you should be all set. When the water heater has a large amount of sediment inside of it, it can make loud popping noises and it cuts down on its efficiency too.

Though water heaters are relatively upkeep free and not hard to operate, any time you feel the tiniest uncomfortable or are not sure of what to do, it is always best to have a plumbing professional aid with the circumstance.

Water Heater Repair Syracuse NY